Actividad del dia 22 de Marzo del 2019

Historial de la figura del dia 4

Command: PLINE
Specify start point: 20,20
Current line-width is 0.00
Specify next point or [Arc/Halfwidth/Length/Undo/Width]:  <Ortho on> 70
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 15
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]:  <Ortho off> 45
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 135
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 135
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 10
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 15
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 12.68
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 15
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]:  <Ortho on> 10
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 10
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 5
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 10
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 20
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 20
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 10
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 20
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: *Cancel*

Historial delineas curvas

Command: FILLET
Current settings: Mode = TRIM, Radius = 0.00
Select first object or [Undo/Polyline/Radius/Trim/Multiple]: R
Specify fillet radius <0.00>: 5
Select first object or [Undo/Polyline/Radius/Trim/Multiple]: M
Select first object or [Undo/Polyline/Radius/Trim/Multiple]:
Select second object or shift-select to apply corner or [Radius]:
Select first object or [Undo/Polyline/Radius/Trim/Multiple]:
Select second object or shift-select to apply corner or [Radius]:
Select first object or [Undo/Polyline/Radius/Trim/Multiple]:
Select second object or shift-select to apply corner or [Radius]:
Select first object or [Undo/Polyline/Radius/Trim/Multiple]: *Cancel*

Historial de circulo

Command: _line
Specify first point:  <Ortho on>
Specify next point or [Undo]: 32.5
Specify next point or [Undo]: 15
Specify next point or [Close/Undo]: *Cancel*
Command:
Command: _circle
Specify center point for circle or [3P/2P/Ttr (tan tan radius)]:
Specify radius of circle or [Diameter]: 10
Command: Specify opposite corner or [Fence/WPolygon/CPolygon]: *Cancel*